Hi guys. So as some of you will have seen over on my Facebook page last week, I made a quilt for my lovely aunt who turned 80 this year. I'll share that with you on here soon. Whilst making that quilt I was kind of up against it time-wise! So instead of doing traditional hand sewn binding like I normally do, I did wraparound binding instead. So today I'm going to show you how to do that. I know that those of you who groaned during classes when I mentioned hand sewing are going to LOVE this!
OK so first you'll want to make sure that your quilting stops about half an inch from the edge of your quilt top. Any ends will need to be buried, as the back won't be covered by binding.
With scissors carefully trim away the excess batting / wadding. Leaving the backing in place.
Trim the backing so there is an inch excess on all four edges.
- At each corner fold the corner in at corner and finger press. Open up and fold the corner into the fold line and finger press. Open out and cut along the second fold line you made. This reduces some of the bulk at the corners when a lovely mitred corner.
- Using an iron, fold and press the backing fabric in half and inch along one edge so that the raw edge of the backing fabric meets the quilt top. Press in place. Now fold it over another half inch so that it has wrapped around and is now sitting on the front covered the raw edge of the quilt top. Press in place along one edge. Pin.
- At the corner fold in at a 45 degree angle as shown. Then repeat the process above: folding the backing in half and inch, pressing in place, then folding in again another half inch and pressing.
- Repeat this process until all four edges and corners are done and pinned in place.
- Now edge stitch in place with your sewing machine. Ideally using a walking foot. Pivot at each corner. Your stitching should be no more than an eighth of an inch from the quilt top. I would not recommend reverse stitching, instead bury your ends inside the quilt.
Hope that all makes sense?!